Piano World Home Page

Tuning Lever and Beats

Posted By: Ladder16

Tuning Lever and Beats - 09/07/09 12:46 AM

Hello Im new to tuning. I just started about 2 months ago I have learned to detect beats but I have some confusion. When listenng for the beats I hear a few different beats (possibly each harmonic above the fundamental.)If that makes any sense which beat should I listen for.

Also what is the proper way to use the tuning lever. I see some guys moving it in a smooth motion while other tuners use a jerking motion.

Any replies will be appreciated
Posted By: JFK

Re: Tuning Lever and Beats - 09/15/09 01:35 AM

Jerking motion tends to cause a more inaccurate adjustment but I suppose it probably sets the strings a little faster...
Posted By: Mark Cerisano

Re: Tuning Lever and Beats - 02/27/15 04:10 AM

I just found these posts in the FAQ section and am wondering why they are here and why some have so few responses. It seems since they are FAQ they should have some fairly concise responses. At the risk of getting the "why are you responding to an old post" flame, ( I never understood why this bothers some people), I would like to add to this thread.

Re: beats. Yes, some intervals have multiple coincidental partials. You may be hearing other partials but only the coincidental partials (C.P.) beat.

Common multiple beating partials.

The P5 has the 1st C.P. an octave above the top note. The 2nd C.P. occurs two octaves above the top note.

When using F2 to tune A4 to the fork, there is a C.P. at A4 when playing F2Fork and F2A4. The 2nd C.P. occurs at A5.

Multiple C.P.'s can have different beat speeds, Therefore it is important to train the ear to seperate out the different beat speeds and focus on the target C.P.

Re: lever technique. This is a huge question but basically the two styles are Slow Pull and Impact/Impulse.

Some technicians swear that one is better than the other, but the fact that different technicians swear by different techniques means some don't use the others technique the same way, certainly not with the same result.

Both ways have their place. An understanding of forces, friction, elastic deformation, and the non-speaking length tension during, and after tuning, is imperitive if you want to be able to acheive stability on all different kinds of pianos.
Posted By: music kitchen

Re: Tuning Lever and Beats - 08/07/16 03:38 PM

In as much as 'notching'/ 'jacking' has its place and time in tuning processes, it is better to get used to 'smooth movement' and change/ adopt the 'jacking' only when necessary as they produce different effect/ results.Experience and guidance via mentoring would be of immense contribution to understanding them both as to when and which...
© 2017 Piano World Piano & Digital Piano Forums